1 / 8
Mazda MX-5 Miata NA/NB/NBFL Hardtop rear bushing plates — image 1
1 / 8

Mazda MX-5 Miata NA/NB/NBFL Hardtop rear bushing plates

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

3D printed replacement for the plastic bushings on the rear adjutment plate of the hardtop

Rating
5 / 5
Likes
11
Downloads
29
Makes
1
Views
254
Reviews
1

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Share Alike

The plastic bushings on my hardtop were completly worn out and damaged by the sun, as you can see in the pictures and I really didn't feel like spending 50€ for two completly new plates. I'm also not sure, if they are even made anymore, because they were out of stock on most of the websites I searched.  

Disclaimer

I modeled these exactly to my plates, but I found out, that the locations of the holes under the plastic are not symmetrical at all, so I had to adjust them individually. I do not know, if the placement of the holes staied the same over the years, or if every batch has slightly diffrent locations for the holes. If yours doesn't fit, you can adjust the hole locations in sketch #2 in the fusion project file (.f3d file), by measuring the distance of the hole to the outside wall of the plate, using calipers and the measuring tool in fusion.

Slicer settings (Orca Slicer)

  • Layer hight: 0.1mm

  • Precise Z height:  enabled (very important)

  • Precise Wall:  enabled

  • do not use PLA, or PETG

  • use at least ABS/ASA, ideally Nylon(PA12)

  • my first version was PETG, it didn't last one winter

Step by step guide

Step #1:

Remove all of the old plastic from the metal plate, using a utility knife or some othe knife with a thin blade, by cutting the plastic in the holes from the rest of the bushing and sliding it off the plate, like in the pictue.

Step #2:

Load the file (Idealy the .step file for better acuracy) into your slicer of choice and add a pause on layer 40 or 41, depending on, if your printer/slicer executes the pause at the bginning or end of the layer. (added mine on layer 40 in Orca Slicer, using my Centauri Carbon) 

Do not enable supports under any circumstances

Step #3:

Start the print and put the metal plate onto an unused part of the heated bed, after the printer has started printing, to preheat the metal.

Step #4:

After the printer has paused, the printed part should look like this:

 

Remove any stringing with a lighter and push the metal plate into the printed part, until it's flush with the part like shown in the picture:

Note, that the plate is not symmetrical and only will go in with the rusty side facing down.

Resume the print and wait until its finished.