Anker MagGo and Zolo Magsafe Charger Ball Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ball mount for the Anker MagGo and Zolo Magsafe QI phone chargers.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 61
- Makes
- 0
- Views
- 545
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
I was tired of needing both hands to unplug my phone and then remove it from the RAM mount. So I upgraded to MagSafe. After some testing, I found that the Anker MagGo had stronger magnets than the original Apple MagSafe charger.
The charger holder is designed to be slim and low profile, and minimize interference with the case--even the iPhone Mini. If you have other ideas for holders for the MagGo or Zolo, let me know. I have included my model of the charger if you want to give it a spin.
Change Log
V4.1 - 2026-6-24
Tightened up for better fit, yet easier to install/remove
Added updates for MagGo models
Fixed issue with all mount balls being 1".
V4 - 2026-06-12
Added Zolo
Removed ball internal structure, gyroid infill performs very similar.
V3 - 2025-09-12
Modified the cable "hider" to be smaller chamfer to match as print angle for less supports
Added cut at 12:00 that makes install and removing charger slightly easier
V2 - 2025-08-30
Added supports into Ram ball – no need for added infill
Added cutouts for additional cooling to charger body
V1 - 2025-05-10
First Release
Print Recommendations
High temp material. ABS, ASA, PC, PET-CF, etc
See note below
PETG should be OK if you are in a cold/cloudy area or if your car is rarely left in direct sun all day.
Polymaker HT-PLA looks promising for those of us with open printers.
0.16mm layer thickness for aesthetics (0.2mm will probably be fine)
3 wall
15% infill - Gyroid
Print as imported, on the angle, so line layers are at an angle.

Environment temps
It gets really hot inside of a parked car, especially at the dash area. In 38ºC/100ºF air, in direct sun, it can reach hotter than 70ºC/158ºF. This pushes filaments to the limit for their HDT (Heat Deflection Temperature). See Prusa's Filament Material Guide.
The only area I have seen deformation is on the ram ball, which is under compression. My black car sits in the direct California sun all day, every day. This was V1 printed Bambu PETG-HF/3 wall layers/15% infill and in my car all summer.
