1 / 3
M5Stack Cardputer-Adv Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Recommended to print at 5% infill with additional wall support. No supports needed and no screws or other fixings. Clean up the posts and check they are not too tight before placing the Cardputer on too firmly, it should lift off with relative ease.
This stand is designed for the Cardputer-Adv but will also work for the standard Cardputer and the standard version 1.1. My other stand is a better fit for these though as the contours of the base are slightly different.