Clothes Peg
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a clothes peg. It holds clothes to clothes lines.
- Rating
- 4.917 / 5
- Likes
- 70
- Downloads
- 703
- Makes
- 14
- Views
- 1,785
- Reviews
- 12
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A few years ago I found this clothes peg on Kickstarter. As usual, they were charging a lot for it. I'm cheap, and Kickstarter has a poor track record.
So, I made a copy of it. Given this is not, technically, my design. Please don't sell them.
Print with any filament, 2 shells should be fine, and whatever infill you want. I'd stick with around 20%.
My dog loves these, so I don't have any pictures to post.
There seems to be an issue with the STL in that it appears to be too small. Even the original file exported from Fusion 360 is the same size. I'm not sure why. To get a proper print from this original version, the peg should be 70mm long, 18mm wide and 5mm thick.
Clothes Peg V2
Edit: I have remade the peg in OnShape, which is much larger and does not require scaling. I have not test printed this one, and it was drawn by tracing over the image and editing smooth. Hopefully this one will work better for people. It is larger than the original version, even after scaling. The gaps are a little bigger too. I hope they're not too loose.