1 / 1
Base for minis
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple bases (25,32,60mm) with room for washer (M10) and magnet (4x2mm) in the bottom.
- Rating
- 4 / 5
- Likes
- 4
- Downloads
- 54
- Makes
- 0
- Views
- 279
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple bases (25,32,60mm) with room for washer (M10) and magnet (4x2mm) in the bottom. They where a bit tricky to slice, but Cura 4.3 made a far better job of it than Cura 4.2.
Attach washers before magnets to make everything a bit easier for yourself. A simple trick to attach the washers is to heat them over a candle for half a minute. They will partially melt PLA and stick when it solidifies. Do not try to do this with magnets, as they loose their strength. PVA glue does the trick.
Category: Games