Prusawire Cable Management - Additional Mods
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Some alternative cable management mods - Remix of @telefaksi's work to add some additional options for Z and X side.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 11
- Makes
- 0
- Views
- 88
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
Overview
This is a remix of Telefaksi's work to add a few other options for wire management under the extrusions. I've added:
An assembly for the Z motor side (allows for three cables, labeled as Z Motor / USB out / network out).
An assembly for the control board side (allows for + / - / nitehawk-USB / PI-USB / Z Motor / Y Motor.
Print Settings
I printed in Prusament Galaxy Black ASA, but anything that is at least PETG should be sufficient.
Voron Print Specs
Layer height: 0.2mm
Extrusion width: 0.4mm, forced
Infill percentage: 40%
Infill type: gyroid
Wall count: 4
Solid top/bottom layers: 5
Supports: NONE
Printed Parts
wiremgmt_zmotor_side.3mf
both parts in correct print orientation
wiremgmt_controlboard_side.3mf
both parts in correct print orientation
Hardware Required
2 x M3 T-nut for 3030 extrusion, printable version if metal T-nuts are hard to find
2x M3x10 SHCS
Assembly Instructions
Insert M3 Roll-in T-Nuts for 3030 Extrusions (
Print all models (PETG is sufficient, but ABS or ASA is nicer!).
Install!