1 / 2
Diamond Tool Holder height gauge
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
setting the 8mm height easy
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 46
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
for the Eccentric Engineering Diamond Tool Holder 8mm (5/16") Tool Height (11mm Shank) Needs to be set at 8mm from the bottom of the 11mm thick shank, aka 3mm down from the top
- one side drapes over the diamond tool holder on the far side for positioning/locking.
- and then also leans into the qctp holder for positioning stability.
- then drops 3mm down so that any toolbit (sharp, flattened for brass, round) is always at the same height (8mm).
- and thus if I do need to change bits, I do not have to align it to the lathe center each time, was the idea at least.
.