Mercedes/Daytona 3 Ton Jack Stand Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DANGEROUS adapter designed for my W212 and the good 3ton Daytona jack stands
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 368
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
WARNING: 3D printing parts to hold thousands of pounds is sketchy! DO NOT use this as the sole method of holding up your vehicle.
Inspired by this design for a different car/stand combo. I reworked it for my W212 + the good 3 ton Daytona jack stands. It will sit way too loosely on the worse version (see below). I would recommend PETG since it has better friction properties + better heat resistance (eg sun). I would also recommend sanding and possibly graphite lube - otherwise the pivot tends to jump instead of moving in a continuous motion (gif shows it skipping a bit - you'll hear it, too).
The design pivots to transmit the force better. It was designed to have one end of the car on the ground, and one end at max jack height, which is just over 10 degrees of tilt. This design also requires that you have the jack post 1-2 clicks higher than the lowest setting, otherwise the neck of the pivot will sit on the stand frame, rather than being fully supported by the post (see the pictures).
More on the good 3 ton stands from this post:
If you're buying a 3 Ton stand, make sure you get the version with the 11 3/8" min height, and not the 11 1/4" version.If you're buying a 3 Ton stand, make sure you get the version with the 11 3/8" min height, and not the 11 1/4" version.