1 / 5
Sovol SV06 BL-Touch / 3D Touch Mount - Strong Design, Clean Appearance
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
BL-Touch / 3D Touch mount for Sovol SV06; two selectable orientations with different X-offsets.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 10
- Makes
- 0
- Views
- 65
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
BL-Touch (or 3D Touch) mount for Sovol SV06.
Two selectable orientations, both placing the probe pin close to the stock sensor:
- Backword mount
- Facing: Connector side front
- X offset: 27 mm (±0 mm)
- Y offset: 20 mm (±0 mm)
- Forward mount
- Facing: Logo side front
- X offset: 28.5 mm (+1.5 mm)
- Y offset: 20 mm (±0 mm)
⚠ Note: Stock Sovol firmware does not support BL-Touch. Use custom Marlin with BL-Touch enabled or Klipper.
Bill of Materials (BOM)
- 1× BL-Touch or 3D Touch sensor
- 2× M3×8 cap head screws
- 2× M3×8 countersunk screws (reuse from SV06)
- 1× JST-ZH-4 connector set
Recommended Printing
- Material: PETG, PETG-CF, ABS, ASA, or similar
- Settings: Wall 4, Top/Bottom 5, Infill 40%, Nozzle 0.4 mm, Layer 0.2 mm
- Orientation: As provided (no supports needed)
Firmware Notes
- Marlin: Enable BLTOUCH and set offsets
- Klipper: Define
[bltouch]section with offsets