50A Anderson PowerPole Protective Cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Took measurements of a 50A connector and basically remade it with divets instead of pins and a small ramp on the…
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 300
- Makes
- 2
- Views
- 990
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
Took measurements of a 50A connector and basically remade it with divets instead of pins and a small ramp on the inside to make disconnection a bit easier on the plastic. It fits quite tight in there, about as tight as another connector would.
Bear in mind these probably wont last too terribly long in terms of plug-unplug cycles (at least in PLA. Haven't tested other materials.)
The supports can be a bit hard to remove but flush cutters/pliers and a craft knife will do the job.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2 mm
Infill:
80
Filament: Hatchbox PLA Black
Notes:
Sliced in Prusaslicer with "Don't support bridges" turned off because my printer cant bridge well (thats my fault).
Hotend 200CBed 60C
on Ender 3 v2
Category: DIY