Waist clip
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.23 – €0.28 net (excluding VAT)
For file: Rock Clip_0.4n_0.2mm_PLA_COREONE_16m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.26 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 16.2 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a clip that can hold a fold in the waistband of a clothing item that is a bit too big.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 23
- Makes
- 0
- Views
- 141
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution
This is a clip that can hold a fold in the waistband of a clothing item that is a bit too big. This is a clip that can hold a fold in the waistband of a clothing item that is a bit too big.
This only works for relatively thin clothes, like skirts, though. For anything thicker like jeans you'd need a belt anyway.
Note, that the side where I have my thumb in the picture goes on the inside. Otherwise it would just turn outside. The side is rounded out, so it should not be too uncomfortable. You maybe need to go over with a blow torch to get rid of any scratchy bits, but other than that, it's fine.
I added a sliced file. It is on the core one, but if you have an other printer, you should still look at it, as the orientation (and supports) and perimeters are quite important for strength. If you'd print it standing up, it will probably brake.
I used PLA and it seems to hold up good enough. But i'd still recommend using PETG or even ABS/ASA, if you have any. Just don't use Silk PLA…