VR Tennis Controller Adapter for the Meta Quest 3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An adapter for playing tennis in VR on a Quest 3. Prints with supports. The clamp needs two M3 screws, M3x20s or longer.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 128
- Makes
- 0
- Views
- 712
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution
I wanted a reliable adapter for playing VR tennis so I made this one. The tracking isn't flawless but it's far more consistent than anything else I've tried.
- You'll need supports for both parts. I recommend tree supports, but anything will work.
- You can print the clamp in any convenient orientation.
- Thread the holes as you go with M3x20 screws (or longer). They should go in pretty easily.
- I added room for M3 nuts if you'd like maximum safety, but I haven't used any so far.
- I used 4 walls and 50-70% infill, both to add stability and to make it feel more like a real racket. If you don't care about the latter, you'll probably be fine with 30% infill. No guarantees though!
Note that I designed the handle to print diagonally on a 256x256 print bed, so you'll need to print at a significant angle if you have less space than that. Just don't stand it on end (even if the adhesion didn't fail, you'd have the layer lines going in a very snappable-during-swings direction).
And keep in mind that a Quest 3 controller with a battery in it is a little below 130g. To tweak the point of balance, you can use modifiers to adjust the infill distribution.
Let me know if you encounter any issues!
