1 / 4
3Kg Spool holder modified
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of an existing Spool holder for spools with a mass of 3kg or less
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 156
- Makes
- 1
- Views
- 476
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Ready to print with .2 mm layer height (need to add support for the drums on the bottom side). Also needs 4 PCS 608 Skateboard bearings.
I advise you to sandpaper the rolls from both sides to make them a bit shorter so they are not touching the holder, and to use a long air balloon rubber to increase the drag between the spool and the rolls, cause without it the spool tends to slip instead of rolling the rolls (also I think regular blue tape will work just fine too)