1 / 9
HSW mount for Slaughter to Prevail / Alex Terrible mask — image 1
1 / 9

HSW mount for Slaughter to Prevail / Alex Terrible mask

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Honeycomb storage wall mount of (official) Slaughter to Prevail / Alex Terrible Kid of Darkness mask

Rating
0 / 5
Likes
15
Downloads
50
Makes
0
Views
1,223
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Honeycomb storage wall mount for the official Slaughter to Prevail / Alex Terrible Kid of Darkness mask, other official or otherwise obtained (3D printed) mask variants may fit but are untested.

Parts and print settings

PLA will do just fine, other (reasonable for this purpose) materials should not be an issue but I've not tested any myself. Print in photos with Das Filament PLA.

  • connectors (4pcs): 9 walls + 15% infill, or (untested) stupid high amounts of infill to make sure the smaller inserts are connected proper with the thicker spacer. Print standing up with auto-support.
  • holder: 3 walls + 15 infill. No supports needed, orient with horn holders pointing up.
  • brace: 3 walls + 15% infill. Orient upside down vs mounting position and paint support on the slanted, angled upwards, horizontal brace. Auto support will fill the connector holes which seems unnecessary and a potential issue for assembly.
Variants
  • flush holder: fit mask flush against HSW
  • offset holder: offset mask from HSW
Assembly

Refer to the ‘all parts reference’ STL. 4 connectors should be fitted to the brace and holder, with HSW inserts to the same side. It helps to fit them first in each part separately to remove any minor artifacts that might make it a bit more of a challenge when fitting the 4 connectors in 8 holes at once.

Optionally add some glue to the connector inserts if you want a more permanent assembly but it is not required.

OpenSCAD

Requires HSW lib and BOSL2, see here for detail. If you want to make edits, be warned it's a bit of a messy file :)

Tags