Card Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A fanning card holder for up to 4 cards. Uses a vertical sliding action. Has fully flush fitting screws.
- Rating
- 5 / 5
- Likes
- 288
- Downloads
- 558
- Makes
- 1
- Views
- 5,610
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A card holder for up to 4 cards that will fan the cards using a slide action. Full credit goes to @nanselm for the design. The changes for this are the screw types as this variant uses 5 socket cap screws which sit fully flush.
HARDWARE (Linked Below):
5x - M3x8mm Socket head screws
3x - M3x3x4.2mm Heat set inserts (3mm deep, 4.2mm diameter)
2x - M3x5x4.2mm Heat set inserts (5mm deep, 4.2mm diameter) - These can be replaced with 3mm deep inserts, however if you have 5mm inserts, these will be better.
Advice:
I printed with 0.1mm layers which worked nicely from a finish perspective.
I would suggest using 100% infill, it is not a heavy part and it helps with strength and feel.
If the holes come out and the mechanism isn't moving freely, try drilling out the pivot screw hole using a 3mm drill bit and do not overtighten it. This goes for any of the M3 holes, they should allow for a screw to slide easily through them so if they don't drilling them out with a 3mm bit will help with assembly, which is for the most part unchanged from @nanselm 's design. There is a photo indicating where each heat set insert is installed to help avoid misintsallation.
AliExpress Links (affiliate) for components:
https://s.click.aliexpress.com/e/_c38v1e0F
https://s.click.aliexpress.com/e/_c4CL8UsL
https://s.click.aliexpress.com/e/_c4CL8UsL