1 / 1
Zohd Talon GT Ruddervator
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement ruddervator for Zohd Talon GT Tail
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 88
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Public Domain
Destroyed my ruddervators during a flipped launch and subsequent crash. This file replaces the foam ruddervators. File is for the right side ruddervator, mirror the model in slicer to get the left side.
Print vertically.
I used these control horns: https://alofthobbies.com/products/basic-servo-horn-pack-of-ten?_pos=1&_sid=c1fda138e&_ss=r
and these hinges: https://a.co/d/epYbt3F
Installation instructions:
- trim away excess foam on the tail
- seat 3x hinges into ruddervator w/ 2 part epoxy or foam glue
- press hinges against tail foam to form indentations and use knife to cut slots into the area where the foam was trimmed
- use foam glue to attach hinges into tail body with the control horn slot oriented close to the fuselage
- insert control horn facing down
- tadaa