Sodasteam Bracket (60L bottle)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Under counter bracket to suspend the 60L Sodastream bottles. No more rolling around or falling over.
- Rating
- 5 / 5
- Likes
- 35
- Downloads
- 136
- Makes
- 2
- Views
- 795
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Share Alike
We usually keep one or two spares around (especially with the pandemic lockdowns where we wanted to minimise any unnecessary travel to the stores).
Of course these were now always in the way, so decided to hide them away.
You could get away with only printing the Soda Stream Bracket v5.stl files. I made the middle bracket (Soda Stream Bracket - Mid piece v1) to minimise the filament usage.
Mounting is done with 3mm screws (you need 2 per bracket, so 6 in total)
When I tried to mount them it wasn't as easy as I thought when doing it alone, and twisting into a cupboard and hanging them upside down and of course placement has to be perfect or else the bottles wont fit (should not be a problem if you skip the middle bracket as alignment would easier, even if not perfect). I quickly designed the placement jig though and made it so that it can be flipped around to minimise prints again. It also ensures the correct space for the back bracket (5cm to the wall)
I printed with Prusament Signal White PETG filament, 15% infill and 0.20mm detail. Printed with the large surface area face down (see attached photo)