Saturn 4 Ultra 12k / 16k Build Plate Handle v2.0
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a wraparound build plate handle for the Saturn 4 Ultra 12k / 16k / non-ultra.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 35
- Makes
- 0
- Views
- 718
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This build plate handle leverages the taper of the leveling spring box on the S4/ S4U to clamp and positively lock. No screws needed, just a dab of glue at each end of the handle and the straps. Note the screws for manual leveling are fully accessible, so removing the handle should not be necessary.
The handle is out front instead of directly above as this gives a lot more control of the build plate while removing prints, especially if you place your thumb on the strap across the front of the spring box.
This version is designed for easy printing in resin or FDM with multiple orientation choices compared to my previous 2-piece handle. All 5 necessary pieces will fit on one S4 build plate. End cap tolerances are good for most resins and filament as far as fitting well to the leveling box. Smaller tolerances used on the straps and handle so they might need a touch of filing or sanding to fit.
If printing in resin, recommend either a tougher ABS, or “Tough” or “Rigid” resin. Pictures are in cheap Colido Rigid resin and feel very sturdy. Recommend a coating of varnish if resin is used as a frequently handled part. If printing FDM, PLA is probably best as it is surprisingly resin resistant compared to some of the stronger and tougher ones like ABS or ASA.
This is a bit semi-final state. I have a few more refinements I would like to make, but this prints and works great at present.
End caps need to be mirrored and straps 2x. Square handle (included) and 14mm round handle options along with a “taller” option for larger hands.
14mm cylinder handle is meant for this aluminum tubing on Amazon which I had already for modifying a coin microscope (microscope is useful for calibration and test prints). https://www.amazon.com/dp/B07YCHG9KF You could of course print a 14x208mm cylinder if you prefer round handles.
Holes in the brackets were cut in Chitubox using the “Dig Hole” tool for making drain holes. Little style choice to add the “speed holes”. Handle was similarly hollowed using the Dig Hole tool with an absurd length.