1 / 2
DDD Dewalt Grabo lifters DCE592B vacuum clamping system — image 1
1 / 2

DDD Dewalt Grabo lifters DCE592B vacuum clamping system

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Printable vacuum clamping system for MFT-style work surfaces and the Dewalt Grabo DCE592B lifters

Rating
5 / 5
Likes
84
Downloads
465
Makes
2
Views
1,980
Reviews
1

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

This project provides the models for a printable vacuum clamping system utilizing the Dewalt Grabo DCE592B lifters.  All fittings are ¼" push connect lines and ¼" NPT thread.

BOM

Tips

  • You're going to need a big printer and there isn't much wiggle room on this.  The baseplate needs to be large enough to cover the lifter, needs to be rigid enough to not bend too much as 600lbs of force is applied, and completely air-tight.  This just doesn't seem possible with two parts fastened together, so the model requires a largish printer.  I'm using a Prusa XL for this.
  • Print all pieces in a material with low porosity, PETG, ASA, and ABS have all been tested with good results.
  • To help create an air-tight print: add perimeters, use concentric top/bottom and a bunch more top/bottom layers, crank the temp up a bit, maybe over-extrude just a little, and use an infill pattern that seals interior cavities such as “cubic”
  • Seal all parts in something air-tight. I found Minwax Polycrylic to be cheap, fast to cure, and air tight after 2-3 coats.  Be sure to coat the inside vacuum path too.  Epoxy and CA glue both were tested, worked, and made a huge mess and were more work than they were worth.  Did make some shiny parts though…
  • Print the included gasket templates, place on the 1/16" foam, and cut with a razor around the perimeters to create a nice vacuum-tight gasket.
  • Clamp works on solid pieces, if the part you're attempting to hold is porous it might have challenges.  Hardwoods and softwoods worked well in my testing, plywood and MDF allows too much air to pass through the piece to work very well.
  • Add valves and splitters as needed, I found a footswitch is REALLY handy to allow hands-free repositioning of your workholding.

Tags