1 / 5
Sammelschiene v2 12/24V mit Abdeckung - Busbar 12/24V with Cover — image 1
1 / 5

Sammelschiene v2 12/24V mit Abdeckung - Busbar 12/24V with Cover

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Sammelschiene für 12/24V mit 3x M8 und 4x M6 Anschlüssen und Abdeckung Busbar for 12/24V with 3xM8 and 4xM6

Rating
0 / 5
Likes
2
Downloads
40
Makes
0
Views
215
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

Sammelschiene für 12/24V Systeme

Update V2

  • Der Träger wurde überarbeitet, die Schraubenköpfe haben jetzt Kontakt zur Kupferschiene.
  • Die Heat Inserts wurden durch M4 Muttern ersetzt.
  • Die Kupferschiene wir durch 2x M4 Schraube am Träger befestigt

Zusammenbau

  • Das Kupfermaterial gemäß der Zeichnung bohren und 2x M4 Gewinde scheiden
  • Schrauben einsetzen und mit einer Mutter sichern (man kann hierauf auch verzichten).
  • Die Kupferschiene mit 2 M4 Schrauben befestigen.
  • Um den Deckel zu befestigen werden zwei M4 Muttern von der Unterseite des Halters eingesetzt.
  • Der Deckel kann dann mit zwei schrauben befestigt werden.

Druck in ASA oder PTEG (Supports werden nur für die Bögen des Deckels benötigt

Was wird benötigt

1x Kupfer Flachmaterial 125x20x3mm oder x4
3x Machinenschraube M8x30 
6x Mutter M8
3x Scheibe und Federring M8
4x Machinenschraube M6x25 oder 30
8x Mutter M6
4x Scheibe und Federring M6
2x Schraube M4x10 oder 12
2x Mutter M4
2x Schraube M4x12

Busbar for 12/24V Systems

Update V2

  • The carrier has been redesigned, and the screw heads now make contact with the copper rail. 
  • The heat inserts have been replaced with M4 nuts. 
  • The copper rail is attached to the carrier with two M4 screws.

Assembly

  • Drill the copper rail according to the drawing and cut 2x M4 threads. 
  • Insert screws and secure with a nut (this step can also be omitted). 
  • Attach rail to body with M4 screws
  • To attach the cover, insert two M4 nuts from the underside of the holder. 
  • The cover can then be secured with two screws M4. 

Print in ASA or PTEG.

BoM

1x Cupper rail 125x20x3mm oder x4
3x Hex Screw M8x30 
6x Nut M8
3x Washer and lock washer M8
4x Hex Crew M6x25 oder 30
8x Mutter M6
4x Washer and lock washer M6
2x Screw M4x10 or 12
2x Nut M4
2x Screw M4x12