1 / 4
PTFE Tube Cuffs (Organiser / Guide for Dual Tubes)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple snap-on guides for pairing two PTFE tubes side-by-side. Keeps filament paths tidy between dryers and MMU setups.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 34
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Public Domain
I designed these to keep things under control between my Creality Space Pi X4 filament dryer and the Prusa MMU2S on my MK3S+. The four dryer tubes were flopping everywhere, so I grouped them two-by-two using these small cuffs.
They are made for 4 mm OD PTFE tubing and snap snugly in place - firm enough not to slide off, but without choking the tubes.
I recommend printing many of them; I started with 10 and instantly needed more.
Print Settings
- Material: PETG (recommended) or PLA
- Layer Height: 0.2 mm
- Nozzle: 0.4 mm
- Infill and Perimeters: recommend 2 perimeters @ 20% rectilinear infill
- Optional: 3 perimeters, but you'll have to configure:
- Arachne Perimeter Generator: enabled
- If printing with 3 perimeters: Advanced > Perimeter transition threshold: 45 ° (or else you may see voids on 3rd perimeter).
- Supports: none
- Brim: may not be required (printed on textured PEI with Bambulab liquid glue)
- Speed: tested successfully at 200% on PETG @ 235 °C (Dragonfly hotend, Prusa MK3S+)