KKm extruder (only bearing) for bearings (with 3 or 4 mm inner diametr ) and other improvements
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Currently, the triangle-lab (and others) gears come with a 3mm inner diameter, which necessitated a model change. Improv
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 89
- Makes
- 0
- Views
- 905
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I have now made over 30 extruders and am sharing my experience. It lets to fix two problems: bad clamping and overheating.
Suitable for printers: k1 series
This version uses: 2 pins instead of 3 a through hole has been added for better pin retention the pin has been replaced with a screw, making it easier to disassemble the extruder if necessary the foot design has been slightly modified so that it does not catch on the screw.
You will need (all versions):
- The pinion gear (or buy a metal pinion gear) and bearing from the stock extruder
- 1x ECAS04 fitting
- 1x M3 washers
- 1x M3x18 wing screw
- 1x tension spring (recommended: diameter - 1 mm, outer diameter - 6 mm, height 12 mm)
- 3x M3x20 DIN 965 (countersunk head screw)
- 1x M3x24 DIN 965 (countersunk head screw) - this screw is needed to ensure the motor screws are the same length, but you can use an M3*20 screw instead
- 6x M3 heat inserts (4.5mm outer diameter, 4mm length)
- 1х bearing MR63 3X6X2.5 (сan be used from a stock extruder)
- 2x M3 nuts (you can use a regular one if you frequently remove the extruder or you can use one with a nylon insert)
And for 4 mm version:
- 2x 4x15mm pins
- 4x MR84ZZ 4X8X3 bearings (NOTE: You may only need 2 bearings; some gears are different—some require 2 bearings, while others only require 1)
And for 3 mm version:
- 2x 3x15mm pins
- 4x MR83ZZ 3X8X3 bearings (NOTE: You will most likely need 2 bearings; Triangle-lab designed the new version of gear so that it currently only accepts 1 bearing; I don't know about other manufacturers)
Printing:
- ABS-CF, PP-GF30, PA-GF30, or better recommended
- Infill: 100%
- Layer Height: 0.12
- Top and bottom shell layers: 4
- Wall loops: 4
Support: tree manual

I highly recommend printing this part in PP-GF30 or PA-GF30, as the bushing shown in the picture, made of weaker plastic, can break during use (I've had such cases, and I personally print this part in PP-GF30).
I print the remaining parts in ABS-CF. Since PP-GF30 is printed slightly differently, this part is available with bushing sizes of 4 mm and 3.8 mm (you'll understand from the file name). Select the desired file.

M3x24 (may M3x20)
