1 / 2
Sterilite 20Qt (19L) Drybox
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is the simplest and quickest to print dry box I can imagine. It holds 3 spools. You need only the following:…
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 37
- Makes
- 0
- Views
- 1,840
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is the simplest and quickest to print dry box I can imagine. It holds 3 spools. You need only the following:
- Superglue
- Two prints of (SteriliteHolder.stl)
- One Sterilite 20Qt (19L) gasket box available everywhere! target, amazon, walmart, etc
- 1/4 inch or 6mm rod. 14 inches or 35 cm length homedepot, amazon
optional:
- Some kind of push fit connector and tube amazon
- Desiccant
Assembly instructions.
- Apply glue to your printed parts and stick them to either end of the box. Keep them in place with a piece of tape while the glue dries. It's important they are roughly level and upright
- Measure your rod and cut it to length with a hacksaw or whatever means you need.
- Done
- Optionally drill a hole through the box and screw in your push fit connector. (PushFitNut.stl)
Category: 3D Printer Accessories