Runcam Scopecam Killflash

These camera's are made pretty robust, and I've gotten lucky that mine hasn't been shot out over the years of playing Airsoft. I play as a Sniper, and I've had my scope cams glare give me away at times. Figured this was a great way to both increase my stealth and protection for the camera.

enjoy!

All these settings below have this print completed in under 15 minutes!

I suggest leaving the infill at 15%, as not much more is needed. If you want to increase strength, though, I recommend swapping the filament out for PETG or even ABS to ensure this sucker really doesn't break; should it get shot. However, PLA will work just fine, might want to replace it after 1-2 shots though.

Change your top and bottom layers from Rectilinear to Concentric for a smooth finish on both ends of the print, with the honeycombs obviously on the plate.

I would also suggest a smooth bed rather than the standard textured plate for a nice finish.

Also, change your infill pattern from Grid to Cubic to save on filament, but also increase structural integrity and internal solid infill to Monotonic.