Flashforge AD5X Print Head Cable Strain Relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This print is designed for TPU. If printed in a rigid filament, this will likely only cause issues.
An expedient strain relief/ cable erector to keep the AD5X Print head cable from getting caught behind the print head with the IFS moved to the left side of the printer.
Printed in 3 year old Duramic TPU which claims to be 95A, 0.2mm layer height, 0.4mm nozzle, on the AD5X. Printed standing up, but after printing I made a few tweaks so you should be able to lay it on the flat side and print it flat (untested). As long as it prints, it should be strong enough with TPUs layer adhesion. Supports are not advised with TPU, but do expect some sagging lines on the top of the strain relief holes.
Mounting it to the printer is easy enough, uses the two existing screws that are near the cable, remove those, pop the strain relief over the cable, slide it to the bottom, and screw the two screws back into place. The third, and left most screw hole is an empty hole on the 3d printer, but an m3x6 fits. (I suspect an m3x3 or larger will do the job, I cannot vouch for anything larger than an m3x6 not damaging something on the inside),
Blend file included.