1 / 7
Birdfeeder XL
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printsettings:
LH: 0.2mm
no support(there is support on the strap)
infill for the top: 40%
I print the feeder in PLA, if the feeder hang in the sunlight, I recommend PETG
You need a buildplate at least with 22 x 22cm
With base_1.1: I rised the outer edge and increasd the gap
I add a base “birdfeeder_window”:
If you print this base with a bright filament, you could see the level of bird seed in the feeder!
Make sure the “window” is printed with a single line of filament.