1 / 2
Tablet mount and cap for RepRack HUGAD shelves
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a practical solution for mounting a tablet on a RepRack shelving system using IKEA HUGAD shelves. The set includ
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
While installing my RepRack Hugad shelves, I realizeds I didn't had enought open roll for the last one.
I choosed to convert the spool shelve to a regular one, using the same mount system for future compatiility.
What's Included
- Tablet Bracket: Secures a tablet to the RepRack poles with #8 1/2" particleboard screws
- Edge Cap: Decorative cover for the cut tablet edge (designed for 10" tablets, 9 7/8" actual size)
- You can probably stretch the model to fit your own tablet if not the same format
Compatibility & Setup
- Shelf System: IKEA HUGAD shelves (cut to 41.5" for this configuration)
- Tablet Size: 10" tablet (tested with 5/8" thick particleboard)
- Tablet Dimensions: 47 7/8" length × 9 7/8" width × 5/8" thick,
- I cut to 41 ½ inch to use with the short HUGAD poles, this leave a thin gap on the shelve and the bracket, mesure according to your own setup.
- Fasteners Required: #8 1/2" particleboard screws (for 5/8 thick board)
Assembly Instructions
- Cut your IKEA HUGAD shelf to appropriate lenght (was 41.5" for me)
- Glue the edge cap to the cut shelf edge using wood glue
- Place the tablet on the two vertical RepRack poles
- Position the bracket underneath and secure with #8 1/2" particleboard screws
Print Settings
- Pretty much any filament and setting should work
Notes
- The edge cap is decorative only and designed for 10" tablets
- Users with different tablet sizes or shelf configurations may need to modify the design