1 / 8
Lilygo Pager Upgrade: Pulsed Coherent Radar (motion/presence) & Relay — image 1
1 / 8

Lilygo Pager Upgrade: Pulsed Coherent Radar (motion/presence) & Relay

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Turn your pager into a doppler-based motion sensor and remote on/off switch. Even senses through some barriers!

Rating
0 / 5
Likes
1
Downloads
8
Makes
0
Views
159
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Upgrade Your Lilygo Pager with a Pulsed Coherent Radar Sensor and Relay (on/off switch)!

The Blackout Comms firmware (v3.1.3 or higher) automatically recognizes and uses the Sparkfun Qwiic Single Relay and XM125 presence/motion sensor, if they are attached properly! 

This allows you to use the pager as an off-grid texting/tracking device, but also as an experimental remote on/off switch & motion/presence sensor!

If properly set up, you'll know the components are recognized because you'll see the blue motion icon and on/off switch show up as they do in this pager screenshot.

The relay is optional, you can always just install the motion sensor if you want. The firmware will auto-detect.

If you haven't already, you'll need to install the Blackout Comms Pager firmware onto your Lilygo Pager. It's free for up to 3 mesh-connected devices, and pretty easy to install.

The two red wires protruding from the back of the enclosure (after you've fully assembled) can be inserted into a circuit (check Sparkfun's docs for current limitations). The pager itself can open and close the circuit.

The flat area of the enclosure (next to the relay cover) is where motion is sensed. Face it toward the area you want to check for motion or human/animal presence.

Motion should be sensed about 5-7 meters away.

You can set motion to notify other devices (via LoRa/mesh) and/or close the attached relay. By default, it just remembers the last time of motion and can answer queries from other trusted Blackout Comms devices.

Note: Be Careful!

If you connect the camera improperly (reversing polarity, shorting, etc) you may destroy the pager or components! Don't do this unless you're experienced working with electronics. I'm not responsible if you mess up your pager!

Simplified instructions (see PDF for details):

  • 3D print the enclosure
  • Create a pin header/adapter for the Pager's expansion port (on top of the pager)
  • Plug together the relay, xm125, & pager
  • Insert the Sparkfun relay & XM125 into the enclosure
  • Attach enclosure to the back of your pager

 

Tags