Syren 10 - Speed Controller Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Housing for the Syren 10 dome motor controller board.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 30
- Makes
- 0
- Views
- 256
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a housing for the Syren 10 dome motor controller board. Just to add some protection to it.
My first design, was good, but needed to re-position the openings a bit. The dip switch & LED openings needed adjusting.
The second print, I'd also increased the inside height a bit to allow the board to slid inside the housing easier.
Version three, had some more minor updates to the opening ends and this is the stl available here.
Print Settings
Printer Brand:
Ultimaker
Printer:
S5
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
25%
Filament: Ultimaker PLA black Post-Printing =============
Notes about the image:
The image above was version 2. It's good enough for me (as I only need one holder), but as stated above, my third attempt is better.
I measured it & drew up in AutoCAD Inventor.
I wanted it to be a snug fit, but also allow access to the terminals, dip switches and also be able to see the LED indicators.
Category: R/C Vehicles