1 / 5
Collapsible Wand w Belt Clasp
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Collapsible Wand for Trick or Treating
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 20
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Share Alike
Collapsible Wand for Halloween
PLA / 0.3 mm layer ht / 2 perimeters / 15% Gyroid infill / Supports on Handle (see figure).
Assemble as shown in figure. A short piece of 1.75 mm filament can be used to lock the end cap in place.
Note: Wand can be extended with a flick of the wrist. Avoid using excessive force, however, since that may make re-collapsing difficult. If that happens, tap small end of the extended wand on a table to loosen it.