Jonsbo N3 Dual SSD Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mount for two 2.5'' SSDs on the Jonsbo N3.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 28
- Makes
- 0
- Views
- 233
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
I saw this post on the TrueNAS forums and bought a PCI bracket that looked the same, but it was too thick and impinged on my heatsink! I couldn't put the top cover of the case back on at all! Ten bucks worth of bent scrap aluminum later and all I could reuse were the SSD screws it came with… ;_;
I also saw this bracket for the N2, but this one takes up less space when installed, and no heatsets are required! All you need are six SSD screws and the two the case came with. I've included the blockout so you can make your own edits but I didn't bother going back and making the bottom screw holes 3.4mm in diameter so it'll be a bit harder to mount the drive but still doable. Both v1 and v2 are confirmed to work by yours truly (trust me bro). Happy printing!
Print settings I used:
- 0.12mm layer height
- Default settings
- PLA
Do not use the default orientation! Put the flat side onto the build plate.