1 / 2
Amateur radio antenna tripod adapter — image 1
1 / 2

Amateur radio antenna tripod adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapter to attach fishing pole to ARCA-SWISS tripod heads to make amateur radio antenna support.

Rating
0 / 5
Likes
4
Downloads
12
Makes
0
Views
299
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

This adapter clamps to the handle of a graphite tenkara fishing pole and allows you to mount it to a camera tripod that has a standard ARCA-SWISS dovetail clamp mount.  

Recommend stronger flexible filament like PCCF, PA, or fiber reinforced ASA or ABS.  I printed one in solid 100% infill PLA and it was strong enough to support the antenna pole, however it did warp in the hot sun, so at minimum, use PETG for a temporary clamp.  Hardware is 3mm screws and hex nuts.

Use with a tripod that allows the legs to be opened nearly horizontal and extend them all the way out to support up to 30-foot poles in light to moderate wind.  The poles must be guyed for higher winds.

It would be impossible to size this correctly for every possible pole diameter, but you can use a piece or two of bicycle inner tube around the handle, or wrap the handle with tape to make smaller poles fit.  For larger poles, a remix is probably the best solution.  This was designed around a 25mm diameter handle, give or take a few mm.

Tags