Aeorian Reverser - Large Monstrocity (DND / TTRPG)

Created through arcane experiments these are the perfect soldiers that hunt their prey and seek violence wherever possible.

This was another fun model today. Like the Yetis I've made a few poses and make an alternate crouch pose based on the reference art. The hands on this model ended up being fine so I kept them as is. Most of my time went to sculpting, posing and cleaning up the models for print. Again like the Yetis I tried decimated from a much higher resolution model. I didn't do a quad remesh in the process this time so the teeth are still sharp instead of stubs. Since these are a two tone creature I tried to sculpt in a deep ridge along on the interior of the creature - hopefully this makes painting easier.

These are large creatures so I've set them at 55m in height on a 50mm baseplate.

For FDM printing usually I recommend printing on their backs but you might be OK printing these upright. A fair amount of supports will be needed to prop up the face so that is something to be mindful of.

For Resin printing I recommend printing without the baseplate. Rotate them back -45 degrees on the x axis and use auto supports.

That's it for these monsters - let me know if you run into any issues or need extra poses.

I'm on a quest to make 1000 dnd models in 2025 and you can join me on Thingiverse, Printables, Cults3d or see my weekly updates on Patreon here: https://www.patreon.com/c/Adamnant (as well as get codes for exclusive downloads on Cults3d). I'm focusing on models that don't seem to exist on Printables / Thingiverse and are listed in campaigns. If you have something that you need or a custom model like this that you want then let me know and let's make it!

Category: Games