Flexible Sanding Block w/ Ergonomic Handle (TPU, infill only block)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A sanding block that is can be made soft or hard depending on the infill percentage used.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 25
- Makes
- 0
- Views
- 185
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
*****************EDIT: I SUGGEST MAKING THE ERGONOMIC HANDLE OUT OF TPU OF THE SAME INFIL % AS THE SANDING PACK SO THAT THEY ALL BEND TOGETHER RATHER THAN THE PAD GETTING SQUISED INTO THE CAVITY. IF YOU CHOOSE TO USE PLA AS THE HANDLE REDUCE THE SANDING PAD HARDNESS BY REDUCING THE INFILL %.******************
A sanding block that is can be made soft or hard depending on the infill percentage used. It comes with an ergonomic handle with a quick release mechanism so that if you decide to print different hardness sanding blocks you can swap them quickly.
Printing instructions:
For the parts that start with PLA i made them into 2 pieces to reduce the supports needed. You can print this at whatever settings you want.
For the TPU parts , as you can tell, it's 2 parts that need to be printed as one. The reason I made them two parts was to have it print as one part with different printing settings. For the bottom part (called “ TPU bottom block no side walls”) you will want to print it with no side walls. You can do no top and bottom layers too it doesnt make a huge difference. You may also choose to use different infill % for the TPU parts. It won't matter much for the part “TPU top block print with walls” as this part is there to connect the handle with the actual sanding block. (refer to pictures)
I did a few different cubes on my ender3 and I found that anything over 20% infill was way too hard, definitely closer to rubber, and 5% was way too soft but it definitely bent nicely around corners. My sweet spot for my application was between 8% and 12%, this is more similar to a foam sanding block for drywall, or like a dish washing sponge. MAKE SURE THAT YOU USE GYROID INFILL, I DID NOT TEST ANY OTHER INFILLS, GYROID IS WHAT WORKED FOR ME.
When placing the parts in cura, you will want to displace “TPU top block print with walls” in the vertical direction by the thickness of the block - in this case around 19 mm. (Refer to pictures)