Air duster holder for IKEA Skadis pegboard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Air duster holder for IKEA Skadis pegboard
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 1
- Views
- 119
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Summary
This is a simple holder that fits most of the electric air dusters on the market, to be used with the IKEA Skådis pegboard.
Measurements where initially made for the PlexGear Air Duster [IK148221]. When looking through the market of electric air dusters, this seems to be one of the more chunky type. Your model will probably fit.
Important: The accessory plate will need to be glued.
Example usage:
General Dimensions
The mount rack is 160mm wide and 60mm in height. The carrying bucket is 90mm high -and will protrude 10mm below the rack when mounted.
Accessory plate is 90x52mm with 30mm addons in height.
You can also use two buckets if you want to. They are translatable to both sides of the backplate.
Print Configuration
- This is a simple print. The only sensitive part is the pegs on the accessory board. These are not generally flimsy as per this example print configuration, but 90° angles on thin plates is generally a bad idea.
- Anything finer than 0.4 nozzles should not be needed
- 15% infill works fine and accessory plate pegs is still fairly strong
- Print as per the image below for a flat print setup
- Supports might not be needed and is basically only for holes higher up on the print. This is generally a waste of filament for something that doesnt need to be perfectly round, and that you can adjust by drilling after the fact.
Mounting
This, as with most better Skådis prints, is made to be used with the fantastic “Skadis T-Nut” system originally made by @6d6178:
