1 / 3
Rail spacing jig for Festool LR32
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rail spacers for drilling holes with the Festool LR-32 system, at 37mm and 22.5mm distances from the board edge.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 72
- Makes
- 0
- Views
- 366
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The Festool LR32 system is a good concept, but the adjustable rail spacers leave much to be desired. They are imprecise, slow, and annoying to use. So I created these spacers, you stick them on the rail and you're done. No adjusting, no screws.
The purpose of the 37mm spacer is obvious, 22.5mm is for drilling holes for hinges in doors.
Print on side. I use 3 wall loops, gyroid infill at 10% and I printed these in ABS and ASA. PLA should work just fine as well.