K1/K1max extruder cable managment
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple cable management system for the back of the K1/K1max toolhead
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 34
- Makes
- 0
- Views
- 333
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
I recently upgraded to DXC extruder on my K1max. This extruder has a filament sensor, and the wires are attached to the MCU from the back of the toolhead. In addition, the motor connection to this extruder requires an extension cable (included with the DXC). Furthermore, I replaced my MCU board, and Creality has changed the connector type for the thermister and heater wires. To use any of my previous nozzles with this new board, I needed a Microswiss conversion kit. As you can imagine, I had a mess of wires hanging from the back of the toolhead.
I first tried ziptie. It was neither very practical nor appealing. Then I remembered that I'd seen a clip months earlier for mounting the BLTouch probe to the back of the toolhead.
So I fashioned this clip using that mount as my guide.
It attaches to the back of K1/K1max using two M2X12mm screws.
Update 1: I've added a second model that is slightly wider and deeper.
You can check out my other models at:
https://www.printables.com/@Toy_Maker_3184077/models
Your “likes” and “boosts” are appreciated.