Nevermore Mini Plus 55 Raised Body for Inverted Electronics

This is a modded main body for a Nevermore Mini Plus 55. I took the original step from Github, reconverted the 55 Plus STL for the stem portion and based it off a spacer originally designed by @orangetruth from the Voron Discord. And since the original connector caps wouldnt fit this anymore, I added new ones designed to fit straight JST-XH 2.5mm Pitch or JST-PH 2.0mm Pitch 5-Pin sockets. I also removed the Wago mounts on the inside and replaced it with a screw-in mount for Isiktechs Nevermore Mini PCB to remove some of the cable clutter on the inside.

https://github.com/xbst/Nevermore-PCB

I included variants for the cable coming out on the left or right side, depending on where you want to mount your filter. The caps have integrated supports for printing, I would recommend some hobby or crafting knife to remove them, but it isnt strictly needed. Be careful when removing though. Especially for the JST-XH variant, as it is only 2 layers above the supports. Sockets press-fit in, but I would recommend some CA-Glue to keep them from coming out when disconnecting cables.

Additionally to the regular Nevermore Mini BOM you will also need:

• 6x M2.5 x 4mm heatset inserts
• 4x M2.5 x 6mm screws for the PCB mount (Look for ones with small diameter heads, some will collide with components on the PCB)
• 2x M2.5 x 10mm screws for securing the caps on
• 2x Roll-in T-nuts or hammerhead nuts for the Extrusion
• 2x M3 x 20mm screws

I wont be making variants for the regular mini or Mini Plus 70, but I provided the step file if you wish to do so yourself