1 / 3
Delta 31-460 Belt Sander Replacement Upper Pulley
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Added pins and holes to align pulley cap for gluing, and expanded center hole to 10.72mm, reduced spacer by 2mm.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 64
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Upper pulley replacement for the Delta 31-460, and clones, belt sander.
Printed PLA+ at 0.2mm layers with 5 or 6 perimeters and top/bottom layers, 15% hex infill. Have not as yet put too much stress on it but if it fails at some point I may just rework it to make the holes for the pins almost full depth to fill with epoxy for strength, and print with 100% infill.
Or experiment with nylon filament. =-)
Krazy glued the cap to the pulley body - the added pins and holes make alignment much easier.