Phillips toothbrush holder for rectangular outlets
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€5.02 – €6.14 net (excluding VAT)
For file: toothbrush wallmount_0.24mm_PLA_MK2S_4h28m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.58 excluding VAT (range midpoint).
- Weight reported by the author
- 93 g
- Print time reported by the author
- 4.47 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Also holds a shaving razor and has hooks for cable management
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 16
- Makes
- 0
- Views
- 384
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Designed for easy printing with minimal supports. If you're wondering about the install location in my photos, it's because I goofed and forgot about the clearance between the bottom outlet and the trim on the sink. In any case, the screw holes are in the correct place and the square cutout will fit around outlets with a ground-fault interrupter (I included a picture of one for clarity). As far as cable management goes, I recommend using a zip-tie after wrapping it around the conical protrusions.
I also included the gcode I used to print this with a Prusa i3 MK2 with a 0.4mm nozzle.