Headset Cup Press Tool for Cane Creek 40 ZS44 ZS56
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a set of two dies for the top and bottom cups of the Cane Creek 40 ZS44 ZS56 tapered headset
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 28
- Makes
- 0
- Views
- 97
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a set of two dies (top and bottom) I designed and used to press in the Cane Creek 40 zero stack tapered headset cups. It may work for other Zero Stack 44 - Zero stack 56 tapered headsets but no guarantees.
It is designed to be used with a ½-13 threaded rod, nuts, and 1-½ washers. I ended up using 2in washers and they worked with no issues. I used two ¾ wrenches to tighten the press slowly until the cups were seated.
I printed them entirely solid by bumping up the wall count until there was no infill. I'm not 100% sure if that was necessary, but it worked and didn't really use that much filament, less than 90 grams total. I printed them in PLA and that seemed to work just fine.