Ignitor Knob for Camp Chef stove
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This replaces the knob on my Camp Chef Pro 60. The model is thicker so that the end of the ignitor shaft is now covered.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 68
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Public Domain
This replaces the ignitor knob on my Camp Chef Pro 60. Photos show an earlier version where the ignitor shaft sticks out past the knob. This model is thicker so that the end of the ignitor shaft is now covered. My ignitor shaft has four small splines at the base, it is definitely the weak point of the stove. If your splines are worn down, you could likely epoxy this on.
I printed this in PLA. .10mm detail, 25% infill, 5 perimeters.
Print “upside down” with the flat area of the knob is down, so that no supports are needed.
Printing in something other than PLA is recommended due to the potential of heat and moisture with a camping stove.