1 / 4
Carplay Radio Mount - KTM 1290 Super Adventure X — image 1
1 / 4

Carplay Radio Mount - KTM 1290 Super Adventure X

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Compact CarPlay/GPS mount for KTM 1290 Super Adventure X — fits OEM GPS bracket cleanly.

Rating
0 / 5
Likes
3
Downloads
13
Makes
0
Views
286
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

Introduction:

A friend of mine bought a CarPlay unit for his KTM 1290 Super Adventure X, but struggled with the usual bulky mounts that stick out too far anbd blocks most of the dash.So, this design was born - a clean, compact alternative that keeps everything visible and in reach.

 

This mount attached directly to the original KTM GPS mounting point behind the visor.

it keeps the CarPlay unit secure without sticking out too much or interfering with your line of sight.

 

Features:

  • Fits KTM 1290 Super Adventure X (2021+) GPS mount location
  • Low-profile design - no more bulky brackets
  • Ideal for CarPlay or GPS displays
  • Minimal obstruction of the dash and screen
  • Included is both the .STL and .STEP files for easy editing.
  • TPU spacer for grip, and protecting the paint on the screen mount

 

Hardware Required:

  • 5x M3.20mm screws
  • 5x M3 nuts

 

Physical Constraints:

  • The screen mount holes are spaced 30mm apart, feel free to edit the .STEP file should your mounts look different.
  • The holes for these mounts are for M4 bolts, use yours accordingly, should they differ.

 

Print Recommendations:

  • Material: PETG/ ABS/ ASA/ etc. (for heat and vibration resistance)
  • Infill: 25 - 50%
  • Layer Height: 0.2mm recommended
  • Supports: Not Required, but recommended underneath the main 12mm rounding.
  • Print Orientation: Print in the orientation as shown in the picture below, this helps compress the layers, and makes the overall print stronger.

Fig 1: Main Mount:

 

Fig 2: TPU Spacer

 

Installation:

  1. Print the main mount and TPU spacer.
  2. Slide the TPU spacer over the OEM GPS Mounting bar.
  3. Press-fit the M3 nuts into the top cover.
  4. Screw in the M3x20 bolts into the 5 locations of the bottom mount.
  5. Loosely fit both the top and bottom to each other.
  6. Slip the main mount over the spacer - It will fit loosely at first.
  7. Tighten the 5x M3x20 screws until the bracket is tight and doesn't move.
  8. Attach the CarPlay or GPS screen using the required bolts for them.
  9. Check the alignment and secure to the OEM mount locations on the visor.

Tags