1 / 3
Percussion Cap Dispenser
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dispenser for 3D printed #10 Percussion Caps
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 92
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Noncommercial
Large and small dispenser for 3D printed #10 percussion caps: https://www.printables.com/model/960060-new-and-improved-10-percussion-caps
Requires super glue and a pens spring or other similarly sized coil spring. I used a .4x5x25mm spring but it works with basically any spring that's between 5-3mm in diameter.
For use, just hold your finger over the loading / unloading port, then move the slider back and forth. This should deposit 1 cap against your finger while closing off the reservoir.