PG7 Blind Stuffing + Nut and TPU-Sealing / PG7 Blindstopfen + Mutter und TPU-Dichtung
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
PG7 blind stuffing to close unused openings for PG7 cable gland in housings (ca 12.5mm). Optional TPU-sealing available.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 122
- Makes
- 0
- Views
- 215
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
PG7 threaded blind stuffing to close unused PG7-openings in housings.
[1] Thread type:
PG thread
[2] Diameters for PG7 opening:
a) threaded hole: 11.3mm / PG thread
b) drill hole without thread: 12.5mm
[3] Sealing:
An optional TPU-sealing model file is available.
Print
Material: PETG (blind stuffing, nut), TPU 95A (sealing)
Supports: not required
Brim: not required
Serial printing (part by part) for better thread quality.
Assembly
Place blind stuffing in PG7 opening and secure with PG7 nut.
Optionally place sealing on stuffing before assembly.
Use a 1€ coin for turning of the blind stuffing.
Hint:
Apply some silicone grease on the thread, so it can be easily be assembled and disassembled.
(Without grease, the thread tends to wind on and off somewhat “sticky”.)