The Chupacabra - a Cryptid Kit Card

Another Cryptid Kit Card!

Using Nakozen's awesome kit card tutorial, these cards print out quite snug and nicely if you stay cognizant of your printer's settings. And don't forget, a good pair of flush snips and a little super glue go a LONG way in keeping these models from falling apart, though the pictures I've attached are all fitted together with no glue at all (so yeah, it's totally possible).

Feel free to use the filament colors of your most base desires - my print of this murderous hound-beast goes from black to grey.  Feel free to experiment with those colors!  I set a filament change around layer 10, though this may differ depending on your slicer's settings. In Cura, go to Extensions → Post Processing → Modify G-Code and select Filament Change.

I've printed my kit cards on both an Ender 3 and an Elegoo Neptune 3+ with more or less identical print settings: 

0.2 Layer Height 

2 Walls 

Outside to Inside Wall Ordering 

A fairly hot build plate (70 degrees C in my case) 

NO SUPPORTS 

and a Skirt 

Also, slow and steady wins this race. I typically print around 45 mm/s for the best results. 

And if you have time, enabling Ironing will give you a spiffy surface finish.