Replacement armrest for 2018 Dacia Sandero

I printed mine in Esun ABS+, had a tiny bit of warping but overall ok with the brim.

Careful about not cooling it too quicly, it is one big chunk of ABS and will crack if you give it the opportunity.

 

I also had a bit of trouble sliding the attachment rod in, due to ABS shrinking of the seat, but solved by placing the rod in the freezer, and the armrest under running hot water for 5 minutes.

I add a pre-cut test sleeve to test your tolerance and resize a little if needed (likely a fraction of a % will do the trick). 

I am including a plain version in addition to the hex pattern one I used. The hex pattern attracted some flak by reddit commenters but after some months of use, with and without long sleeves, I can say it doesn't feel uncomfortable to me, and I still like the look.

The drawers are meant to go in the third and fouth slot from the tip.

First and second are too small to be useful, fifth is most likely blocked by the passenger seat (the fourth may already be difficult to use).

The lid is not tested. 

I designed it for the sake of completeness, but actually haven't printed it and it is not really needed.