Pneumatic Can Crusher Mounting Brackets
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€8.28 – €10.11 net (excluding VAT)
For file: Can_Crusher_Bracket_Mid_0.15mm_PETG_MINI_10h38m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €9.19 excluding VAT (range midpoint).
- Weight reported by the author
- 91 g
- Print time reported by the author
- 10.64 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Set of brackets to wall mount a pneumatic can crusher.
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 57
- Makes
- 0
- Views
- 1,801
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
A simple set of brackets to allow wall mounting of a pneumatic can crusher (such as this one from Amazon: Pneumatic Can Crusher).
The rear bracket has a lip which will snap over the cylinder end cap to hold it in place. The mid-section support bracket has two slots to allow bolts up to 6mm to be installed to bolt the crusher onto it. These however are optional (the snap-on end cap will hold the crusher firmly and prevent it from sliding off the mounts).
Rear bracket has a cut-out to allow access to the adjustment screw on the rear of the cylinder.
Both brackets have a lower access hole through the support to allow a screwdriver to be inserted to screw it onto the wall, or for a punch to be inserted to drive in nylon anchors (these are what I've used.) The two upper mounting holes on each bracket can be easily accessed from the side of the brackets.
Brackets are sized to allow printing on a Prusa Mini+.
All mounting holes are 5mm diameter.
The print settings I used were:
Prusa Mini+ Printer
Prusament Jet Black PETG
0.15mm quality layer height
5 Perimeters for strength
40% gyroid infill
No supports needed