Battery Powered WLED Floodlight Mounts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A temporary system for mounting RGB LED floodlights, a battery and controller to trees without damaging them
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 15
- Makes
- 0
- Views
- 316
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are the 3D printed components for my temporary tree floodlight setup from this video
✨ Features
Temporarily mount your WS2811 floodlights to a tree of any size without damaging it. Use the waterproof battery box to install a wireless controller and to hold a Milwaukee M12 tool battery using the included battery receiver model.
🔗 Links
Printing Details
These prints are all incredibly simple, no magic here!
Recommended material: ASA or PETG (for heat and UV resistance, ASA if you're using in Summer)
Layer height: 0.25 mm
Infill: 20% (Gyroid or Grid)
Perimeters: 2+
Supports: Not required
Orientation: Print on the flat side!
Hardware
To assemble, you'll require the following hardware
- 2 x M4 x 25mm countersunk screws (for fixing the battery mount in place)
- 4 x M3 x 12mm screws to attach Box_Mount to Box_Bottom
- 6 x M3 x 25mm screws for the latches
- 1 x M4 x 12mm countersunk screw to ‘lock’ the box and prevent access
- 2 x PG7 glands to pass cables through
To replicate the video, you'll also need
- 10W LED Floodlight
- WLED Controller
- Pigtails (I cut extensions in half)
- Any 25mm (1 Inch) strap should work fine