6-inch Rack Sodola 5-port Switch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Need a network switch for your 6" rack? This little switch works well!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 17
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Need a network switch for your 6" rack? This little switch works well!
Switch: https://www.amazon.com/dp/B0BLTK8Q87
Optional: Use some double-sided mounting tape in the back to keep it in place, the tape will make it flush.
- Double-sided tape used: https://www.harborfreight.com/8-12-ft-x-34-in-double-sided-mounting-tape-63948.html
Optional again: USB-C plugs that can be mounted below the switch to make powering easier.
- Plugs used: https://www.amazon.com/dp/B0C7CPYL79
This was made specifically for the rack made by Mauker:
https://www.printables.com/model/1173696-3d-printable-rack-10-inch-and-6-inch/
Here are the same settings from the rack above, these worked for me:
Supports:
No
Resolution:
0.2 or 0.24
Walls/Perimeters:
At least 3
Infill:
25% or more
Filament:
PLA+/PETG/ABS/ASA/PC/Nylon
The switch will have some heat so it is suggested to try PETG first, but I am sure it'll be fine with PLA+.
Did you enjoy this model? Help support me with a tip: https://ko-fi.com/chriskewl